I rebuilt my idle sprocket last night, it went pretty well. I cleaned the bearings, sprocket, and the gear stopper thing. I'm not sure what they are called but it's the little pieces that stops the sprocket from moving backwards.
![]() |
bearings, springs, and gear stoppers soaking in carb cleaner |
![]() |
Back side of Idle Sprocket with clean bearings packed in new grease |
![]() |
Once all the bearings are greased up it should be pretty easy to flip the sprocket over with out losing any bearings |
![]() |
I'm not sure what these are called but they seem to hold down the clips that stop the sprocket from moving backwards and the screw cap. |
![]() |
Installing the clip things I was just referring to |
![]() |
and now the 3 ring covers |
![]() |
Installing the clean bearings and grease on the front side over the sprocket |
![]() |
All the bearings installed |
![]() |
Adding grease to the screw cap After that I screwed the cap on (counter clock wise) and tapped it tight then spun it around a couple dozen times and wiped all the excess grease that seeped out. |
No comments:
Post a Comment