If you recall I attempted to install my crank bearings a couple weeks ago with little success. Every time I started cranking the bearing down it would start to get a little crooked and get stuck. Now with a second pair of hands and a handy Emeralds Peanuts container they went on with no problem.
A preview of our rig
Bill approving our setup after
success of the first bearing.
Image of both bearings sitting nicely on the crank
Snap ring install
Both bearings and seals and clutch bushing
installed. that went really well.
Next I'm going to clean the clutch bell and probably replace the springs and continue the engine build
No comments:
Post a Comment