I've been looking for a pipe that would fit perfectly in the tail end of the frame, but I haven't had much luck with that. This piec...

I started by drilling two/three holes into my frame. I say three because there is two layers you have to drill through on the top bar of the...

Over the last month I didn't get as much done as I would have liked, but between getting sick and the holidays time just flew by. My new...

After I reassembled the forks I couldn't resist to do a little mock assembly. I'm going to tear it back down to drill the holes in t...

First I cleaned the bushings and  unscrewed the fork springs, then I scrubbed the springs down in my trusty trash can of gasoline. (it was ...

I installed the forks and swing arm. I will post more pictures of the fork installation once I find my pictures. The right hand...

Mounted the tires, all went as planned and i'm happy with the results.

I painted my 19 mm intake I purchased  (thanx   orangerobin ) on www.Mopedarmy.com and painted my handlebar clamps, then I inst...

Since i finally got my Google check, i decided it was time to buy some more parts. I ordered this batch from  Treat Land , the descriptions...

I finally decided it was time to start putting stuff in the casing. w00t! Giving the e50 one more bath before I put it to work.  Next,...

We didn't trust that there was enough area available for the gasket to make a good seal where the engine and the cylinder meet. So Bill...

After visiting the Moped Army, I was told my best bet would be to J-B Weld the hole I created. So I went out and bought some "slow...

I want to start out by saying I know it's not perfect but once i went too deep on one side I didn't want to push my luck, I figured ...