Since i finally got my Google check, i decided it was time to buy some more parts. I ordered this batch from  Treat Land , the descriptions...

I finally decided it was time to start putting stuff in the casing. w00t! Giving the e50 one more bath before I put it to work.  Next,...

We didn't trust that there was enough area available for the gasket to make a good seal where the engine and the cylinder meet. So Bill...

After visiting the Moped Army, I was told my best bet would be to J-B Weld the hole I created. So I went out and bought some "slow...

I want to start out by saying I know it's not perfect but once i went too deep on one side I didn't want to push my luck, I figured ...

All went as planned, took off the old bearings with my puller and pressed the new ones on.  Pulling off old bearings Image of bare shaf...

I painted my rear wheel sprocket, brake assembly and my engine gear sprocket.  I'm going to reassemble the rear wheel tomorrow after the...

These went in pretty easily a lot faster then getting the old ones out. I laid the bearings flush and gave it a whack with a rubber malled. ...

I rebuilt my idle sprocket last night, it went pretty well. I cleaned the bearings, sprocket, and the gear stopper thing. I'm not sure w...

If you recall I attempted to install my crank bearings a couple weeks ago with little success. Every time I started cranking the bearing d...

WARNING!  DO NOT SANDBLAST & POWDER COAT YOUR WHEEL WITH THE BEARINGS  INSTALLED Now that I got that warning out of the way. let me sho...