I finally decided it was time to start putting stuff in the casing. w00t! Giving the e50 one more bath before I put it to work.  Next,...

We didn't trust that there was enough area available for the gasket to make a good seal where the engine and the cylinder meet. So Bill...

After visiting the Moped Army, I was told my best bet would be to J-B Weld the hole I created. So I went out and bought some "slow...

I want to start out by saying I know it's not perfect but once i went too deep on one side I didn't want to push my luck, I figured ...

All went as planned, took off the old bearings with my puller and pressed the new ones on.  Pulling off old bearings Image of bare shaf...

I painted my rear wheel sprocket, brake assembly and my engine gear sprocket.  I'm going to reassemble the rear wheel tomorrow after the...

These went in pretty easily a lot faster then getting the old ones out. I laid the bearings flush and gave it a whack with a rubber malled. ...

WARNING!  DO NOT SANDBLAST & POWDER COAT YOUR WHEEL WITH THE BEARINGS  INSTALLED Now that I got that warning out of the way. let me sho...

Well I got the front wheel reassembled, I think i need to do some fine tuning on the bearing pressure. I had to go to Auto Zone and buy...

Well I finally got back to the front wheel. I cleaned out the bearing races with a q-tip and some carburetor and below is a picture of my be...

Last night I removed the brake assembly and the bearings, it was a bit tough. I'm going to clean them today and go pick up some new g...

Well i'm using the freeze and heat method. Here is my crank getting nice and cold Here are my bearings cooking. I don't...

Thanx to Description Quantity Price Puch E50 Green Seal Kit 1 $9.99 Puch Crankshaft Bearing Set 1 $16.99 Puch E50 Gasket Kit 1 $10.99 Puch R...